Blaupunkt Granada SQR49

Hi
Does anyone know how to set this radio back to a default code? or know how to remove the code.?
when i power up the radio all i get is " - - - - " on the display. it did at on time show CODE
And one last thing what do each of the wires do ? I've sussed Red and Black and i think the yellow one is the memory, but not sure on the orange & blue one. Also which speaker wires are which i.e left front right front etc.

thanks

In article ,
says...
but not sure on the orange & blue one.

"Normally" orange is mobile phone mute or illumination (depends on the
car or headunit). Blue is usually power antenna/amp remote switching
power.
--
The poster formerly known as Skodapilot.
http://www.bouncing-czechs.com

I have emailed you a very helpful chap's email address who can issue you
with a code for £9

CODE means the radio is ready for Code entry

---- means you have to wait for CODE/COD to be displayed. This could take a
couple of hours as it locks you out for a few minutes accumilatively every
time you enter an incorrect code (and if you enter the wrong code too many
times then unfortunately you are locked out indefinitely)

No idea about wires. Sorry

Jim

"mehere" wrote in message
...
Hi
Does anyone know how to set this radio back to a default code? or know how
to remove the code.?
when i power up the radio all i get is " - - - - " on the display. it did
at on time show CODE
And one last thing what do each of the wires do ? I've sussed Red and
Black and i think the yellow one is the memory, but not sure on the orange &
blue one. Also which speaker wires are which i.e left front right front etc.

thanks