Where to feed battery thru 4 Vectra
It is Possible. I did mine after a lot of head scratching...
i've got a 97 vectra.
with the bonnet up:
the battery on the right hand side.
remove the rubber seal (about a foot) holding down the plastic cover (enough to see underneath)(just lift a bit) which covers my air con filter.
look on the right hand side; there's a grommet which leads behind the glove box.
pop out the glove box, about 5 screws. and u have lots of room to work.
then route the cable as needed.
Hope this helps.
Mike
"Craig" wrote in message ...
if the vectra is anything like the mk4 astra - you'll be drilling in
very tight spaces behind the glove compartment - not a nice job...will
require two people...one to drill and the other to keep an eye on
where the drill bit is goin to in the engine bay
i've got a 4AWG cable running to my boot install, a 8AWG going to my
HU and also the alarm fitters drilled another for my alarm...more
holes than swiss cheese!
make sure you seal up properly and 'wax oil' up too - just for good
measure
On Tue, 28 Oct 2003 21:29:06 GMT, russ100
wrote:
Hi
I need to feed a cable from the battery to my sub/amp Has anyone done
this for a Vectra, is there a hole there already or will I need to make
one ?
Any help appreciated,
Russell
|
Linear Mode
