Bi-wiring vs bi-amping
Glenn Richards wrote:
Eiron wrote:
Actually, it would be difficult for him to get it wrong. Switch the
Arcam into bi-amp mode and the two outputs are gain-matched to the
accuracy of the feedback resistors, so with 1% resistors the worst
case would be 0.3dB difference.
Finally, someone with a clue.
But you with your golden ears must be able to hear that much difference.
Better check the relative gain with your DVM.
Oh, I'm certainly insane, or at least borderline. Just ask anyone who's
ever been a passenger in my car when I've been feeling "playful"!
"Insane" is driving down a country lane at over 100mph in the pouring rain.
"Stupid" is doing the above whilst being chased by a police car.
I've done the "insane", but not the "stupid".
Although we would all enjoy reading your obituary in the Wotton Gazette,
your behaviour is likely to kill an innocent family as well so here's some advice:
There's always someone faster than you and today could be the day you meet him
coming the other way on your wet, narrow, twisty country lane.
--
Eiron
No good deed ever goes unpunished.
|