Here is what you will want to do
take a shotgun and point it at the firewall in the general area that you
what the wire to pass through. You may also use a high caliber hand gun,
but I have found that the shot gun produces a spatter effect allowing for
future accessory holes.
make sure nobody is in the vehicle and be sure to aim clear of the fuel
line.
Eye and ear protection is also recommended
Good Luck

JK
Bonnet, you must be European
Here in the closed minded USA that can only be referred to as a hood

"thelizman" thelizman1221.yahoo@com wrote in message
...
Johan Wagener wrote:
I can't seem to find a place from inside the bonnet to inside the car
where
I can run my power cable through. I found a few other wires going
through
there but I can't get to the place where they come out in the bonnet.

Any experiences with a escort?

Depends on the year escort, but if it's 92 or newer, you're just going
to have to drill...carefully...and use a grommet to protect the wires
insulation...and tie the wire into a small loop so water won't travel
down the outside of the wire and into your car...and slap a little latex
or weather stripping sealant on there too.

Bonnet!?

--
Lizard
Wierd assed foreigners : P