92 On Look in the corner of the inner wing on the passanger side of the
engine bay, you will see a big hole where the wire to the side repeater
goes.

Jack the front passenger side of the car up and remove the passenger front
wheel, Then drop the wheel arch liner down, undo the torx and clips that
hold it up. You will then see a massive rubber grommit going into the
passenger footwell where the wiring loom from the engine bay to the car is.
Push amp cable through hole in top of engine bay then through the massive
grommit loads of room in there if not use some lubricant to help ease it
through. If cant be bothered just make anew hole through it but make sure it
is sealed. Bolt the wheel arch liner back up, Stick wheel back on remeber to
tighten bolts when the wheel is on the ground remove jack.

"Johan Wagener" wrote in message
...
I can't seem to find a place from inside the bonnet to inside the car
where
I can run my power cable through. I found a few other wires going through
there but I can't get to the place where they come out in the bonnet.

Any experiences with a escort?