On Thu, 27 Nov 2003 07:01:38 -0500
"Arny Krueger" wrote:


Heating disturbs the wire's plastic insulation, which provides a
significant amount of strength and resistance to sharp bends.

Oh please, the last shred of insulation at the end of the wire provides
near zero additional strength, and besides:

1) The cable itself ought to be clamped before entering the strain
relief.
2) If you're melting the insulation you have either crap wire or no
soldering skill whatsoever.

I have *NEVER EVER* had the actual solder joint or copper wire near it
fail in any of the hundreds of leads I've made over the years. the only
failures I have ever had have been fracturing of the wire *after exiting
the strain relief*, and even then only after a good long service life.
(ok so the occasional one had a dry joint too, no-ones perfect)

--
Spyros lair: http://www.mnementh.co.uk/ |||| Maintainer: arm26 linux

Do not meddle in the affairs of Dragons, for you are tasty and good with
ketchup.