"Meat Plow" wrote in message
news
On Mon, 17 May 2010 09:57:09 +0100, Arfa Daily wrote:

Hi all

Anyone happen to know the value of the resistor in the CR network
connected in the synchronous motor feed ? Looks like brown - red - brown
so 120 ohms, but it's well overheated and discoloured, with a nice burn
mark right around the spiral element, right in the centre. Can't get a
reading from either end to the burn point. Looks at a guess to be rated
about 3 -5 watts. Anybody think of a reason *not* to use a wirewound
rather than the original metal film type ?

Arfa

Did you try a 120 and see what happens (with some current limiting in
place) With things like this I usually clip in a light fuse in case the
resistor was actually 1200 ohms or more

If no closer to a definitive answer by tomorrow, Meat, I'll probably go down
that route.

Arfa