I wonder if anyone would provide advice on speaker cable selection.

I have an Arcam amp connected to Kef Q35 speaker via Cable Talk 3.1 Biwire
cable. Following a move round I need to buy some cable which I can run
under the carpet and bend round corners without causing a huge ridge in the
carpet. The current bi-wire cable is not going to fit the bill.

Hence, can anyone recommend a suitably thin bi-wire cable that isn't going
to cost the earth and is thin enough to go under a carpet and bend without
too much problem. I have thought about Supra Rondo 4x2.5. Or should I just
get a more expensive non bi-wire cable and forget bi-wiring.

Any advice gratefully recieved!

Allan Clark

In article , Alan C Clark
wrote:
I wonder if anyone would provide advice on speaker cable selection.

I have an Arcam amp connected to Kef Q35 speaker via Cable Talk 3.1
Biwire cable. Following a move round I need to buy some cable which I
can run under the carpet and bend round corners without causing a huge
ridge in the carpet. The current bi-wire cable is not going to fit the
bill.

IIRC Maplin do some 'flat' LS cables which might serve your purpose. Have a
look at their website and see what you think.

Hence, can anyone recommend a suitably thin bi-wire cable that isn't
going to cost the earth and is thin enough to go under a carpet and
bend without too much problem. I have thought about Supra Rondo 4x2.5.
Or should I just get a more expensive non bi-wire cable and forget
bi-wiring.

Up to you. Personally, I would not bother with bi-wiring.

Slainte,

Jim

--
Electronics http://www.st-and.ac.uk/~www_pa/Scot...o/electron.htm
Audio Misc http://www.st-and.demon.co.uk/AudioMisc/index.html
Armstrong Audio http://www.st-and.demon.co.uk/Audio/armstrong.html
Barbirolli Soc. http://www.st-and.demon.co.uk/JBSoc/JBSoc.html

I would use two individual runs of QED silver micro @£3.50/m to each
speaker.

Borosteve.