Audio Banter

Audio Banter (https://www.audiobanter.co.uk/forum.php)
-   uk.rec.audio (General Audio and Hi-Fi) (https://www.audiobanter.co.uk/uk-rec-audio-general-audio/)
-   -   Phono Plug Uses (https://www.audiobanter.co.uk/uk-rec-audio-general-audio/6133-phono-plug-uses.html)

Geoff Lane November 12th 06 12:25 PM

Phono Plug Uses
 
I've misplaced the manual to an AIWA NSX-5777 music centre.

What is the purpose of the Line Out sockets, is Line Out an
unamplified signal as opposed to the various speaker outputs which I
assume are amplified.

Geoff Lane


Keith G November 12th 06 12:39 PM

Phono Plug Uses
 

"Geoff Lane" wrote in message
...
I've misplaced the manual to an AIWA NSX-5777 music centre.

What is the purpose of the Line Out sockets, is Line Out an
unamplified signal as opposed to the various speaker outputs which I
assume are amplified.




Line Out is a signal at line level which is *unaffected* by the amplifier's
Tone, Volume, Balance &c. controls and is used to feed a 'Slave Amplifier'
or active subwoofer as in page 6 of this .pdf manual for the currently
available Acoustic Solutions SP101 amplifier:

http://www.acousticsolutions.net/PRODUCTS/IMS/SP101.pdf

....which is no *power house* but a perfectly useful and very versatile
little amp for only 60 nicker from Argos!!

I use mine to 'gather' signals and route them to a valve amp via the Line
Out. The only downside is that there is no 'remote volume control' going
this way and the amp has to be on (with Speakers Off) to enable
switching....




Kalman Rubinson November 12th 06 03:03 PM

Phono Plug Uses
 
Line Out usually IS affected by all volume/tone controls. Tape Out is
what you have described. At least for most domestic equipment
although there will be exceptions.

Kal


On Sun, 12 Nov 2006 13:39:40 -0000, "Keith G"
wrote:


"Geoff Lane" wrote in message
.. .
I've misplaced the manual to an AIWA NSX-5777 music centre.

What is the purpose of the Line Out sockets, is Line Out an
unamplified signal as opposed to the various speaker outputs which I
assume are amplified.




Line Out is a signal at line level which is *unaffected* by the amplifier's
Tone, Volume, Balance &c. controls and is used to feed a 'Slave Amplifier'
or active subwoofer as in page 6 of this .pdf manual for the currently
available Acoustic Solutions SP101 amplifier:

http://www.acousticsolutions.net/PRODUCTS/IMS/SP101.pdf

...which is no *power house* but a perfectly useful and very versatile
little amp for only 60 nicker from Argos!!

I use mine to 'gather' signals and route them to a valve amp via the Line
Out. The only downside is that there is no 'remote volume control' going
this way and the amp has to be on (with Speakers Off) to enable
switching....




Rob November 12th 06 05:38 PM

Phono Plug Uses
 
Kalman Rubinson wrote:

On Sun, 12 Nov 2006 13:39:40 -0000, "Keith G"
wrote:

"Geoff Lane" wrote in message
...
I've misplaced the manual to an AIWA NSX-5777 music centre.

What is the purpose of the Line Out sockets, is Line Out an
unamplified signal as opposed to the various speaker outputs which I
assume are amplified.



Line Out is a signal at line level which is *unaffected* by the

amplifier's
Tone, Volume, Balance &c. controls and is used to feed a 'Slave

Amplifier'
or active subwoofer as in page 6 of this .pdf manual for the currently
available Acoustic Solutions SP101 amplifier:

http://www.acousticsolutions.net/PRODUCTS/IMS/SP101.pdf

...which is no *power house* but a perfectly useful and very versatile
little amp for only 60 nicker from Argos!!

I use mine to 'gather' signals and route them to a valve amp via the

Line
Out. The only downside is that there is no 'remote volume control'

going
this way and the amp has to be on (with Speakers Off) to enable
switching....


Line Out usually IS affected by all volume/tone controls. Tape Out is
what you have described. At least for most domestic equipment
although there will be exceptions.

Kal


I thought line out was line level (2V) and fixed, and headphone out (in
this situation) and speaker out (on sound cards) do the variable thing?

Rob

Keith G November 12th 06 07:43 PM

Phono Plug Uses
 

"Rob" wrote in message
...
Kalman Rubinson wrote:

On Sun, 12 Nov 2006 13:39:40 -0000, "Keith G"
wrote:

"Geoff Lane" wrote in message
...
I've misplaced the manual to an AIWA NSX-5777 music centre.

What is the purpose of the Line Out sockets, is Line Out an
unamplified signal as opposed to the various speaker outputs which I
assume are amplified.


Line Out is a signal at line level which is *unaffected* by the

amplifier's
Tone, Volume, Balance &c. controls and is used to feed a 'Slave

Amplifier'
or active subwoofer as in page 6 of this .pdf manual for the currently
available Acoustic Solutions SP101 amplifier:

http://www.acousticsolutions.net/PRODUCTS/IMS/SP101.pdf

...which is no *power house* but a perfectly useful and very versatile
little amp for only 60 nicker from Argos!!

I use mine to 'gather' signals and route them to a valve amp via the

Line
Out. The only downside is that there is no 'remote volume control'

going
this way and the amp has to be on (with Speakers Off) to enable
switching....


Line Out usually IS affected by all volume/tone controls. Tape Out is
what you have described. At least for most domestic equipment
although there will be exceptions.

Kal


I thought line out was line level (2V) and fixed, and headphone out (in
this situation) and speaker out (on sound cards) do the variable thing?




'Pre Out' is the one where the signal can be modified by the 'host' amp's
pre section...






Laurence Payne November 13th 06 12:54 AM

Phono Plug Uses
 
On Sun, 12 Nov 2006 13:25:59 +0000, Geoff Lane
wrote:

I've misplaced the manual to an AIWA NSX-5777 music centre.

What is the purpose of the Line Out sockets, is Line Out an
unamplified signal as opposed to the various speaker outputs which I
assume are amplified.


Basically, yes.

Line Out suits Line In of a recording device, or maybe Line In of an
additional amplifier.

Geoff Lane November 14th 06 07:10 PM

Phono Plug Uses
 
On Sun, 12 Nov 2006 13:39:40 -0000, "Keith G"
wrote:

I've misplaced the manual to an AIWA NSX-5777 music centre.

What is the purpose of the Line Out sockets, is Line Out an
unamplified signal as opposed to the various speaker outputs which I
assume are amplified.




Line Out is a signal at line level which is *unaffected* by the amplifier's
Tone, Volume, Balance &c. controls and is used to feed a 'Slave Amplifier'
or active subwoofer as in page 6 of this .pdf manual for the currently
available Acoustic Solutions SP101 amplifier:


So the line out could actually go to some battery operated computer
type speakers.

There's a couple of other sockets I'm not too sure about;

below is a link to an image of the sockets,
http://www.3lanes.dsl.pipex.com/temp/phono.jpg

What are the MD sockets for.

Geoff Lane


Don Pearce November 14th 06 07:13 PM

Phono Plug Uses
 
On Tue, 14 Nov 2006 20:10:55 +0000, Geoff Lane
wrote:

On Sun, 12 Nov 2006 13:39:40 -0000, "Keith G"
wrote:

I've misplaced the manual to an AIWA NSX-5777 music centre.

What is the purpose of the Line Out sockets, is Line Out an
unamplified signal as opposed to the various speaker outputs which I
assume are amplified.




Line Out is a signal at line level which is *unaffected* by the amplifier's
Tone, Volume, Balance &c. controls and is used to feed a 'Slave Amplifier'
or active subwoofer as in page 6 of this .pdf manual for the currently
available Acoustic Solutions SP101 amplifier:


So the line out could actually go to some battery operated computer
type speakers.

There's a couple of other sockets I'm not too sure about;

below is a link to an image of the sockets,
http://www.3lanes.dsl.pipex.com/temp/phono.jpg

What are the MD sockets for.

Geoff Lane


Mini Disc, maybe? If they are, then they are standard Line In
connections.

d

--
Pearce Consulting
http://www.pearce.uk.com

Keith G November 14th 06 10:03 PM

Phono Plug Uses
 

"Geoff Lane" wrote in message
...
On Sun, 12 Nov 2006 13:39:40 -0000, "Keith G"
wrote:

I've misplaced the manual to an AIWA NSX-5777 music centre.

What is the purpose of the Line Out sockets, is Line Out an
unamplified signal as opposed to the various speaker outputs which I
assume are amplified.




Line Out is a signal at line level which is *unaffected* by the
amplifier's
Tone, Volume, Balance &c. controls and is used to feed a 'Slave Amplifier'
or active subwoofer as in page 6 of this .pdf manual for the currently
available Acoustic Solutions SP101 amplifier:


So the line out could actually go to some battery operated computer
type speakers.




Only if they have some sort of amplification...??



There's a couple of other sockets I'm not too sure about;

below is a link to an image of the sockets,
http://www.3lanes.dsl.pipex.com/temp/phono.jpg

What are the MD sockets for.



That's a little bit confusing as I would guess the Video/Aux and MD (line
level) to be inputs.

If the Line Out sockets do not provide a line level signal to another
amplifier/recorder/whatever then they are possibly an input for another
gadget's Line Out sockets, IYSWIM - poor labelling or poor grouping, I would
say, but you are unlikely to do any great harm if you have a bit of a poke
about with another source....??

Volume control set very low, of course....








harrogate3 November 14th 06 11:19 PM

Phono Plug Uses
 

"Keith G" wrote in message
...

"Geoff Lane" wrote in message
...
On Sun, 12 Nov 2006 13:39:40 -0000, "Keith G"


wrote:

I've misplaced the manual to an AIWA NSX-5777 music centre.

What is the purpose of the Line Out sockets, is Line Out an
unamplified signal as opposed to the various speaker outputs

which I
assume are amplified.



Line Out is a signal at line level which is *unaffected* by the
amplifier's
Tone, Volume, Balance &c. controls and is used to feed a 'Slave

Amplifier'
or active subwoofer as in page 6 of this .pdf manual for the

currently
available Acoustic Solutions SP101 amplifier:


So the line out could actually go to some battery operated

computer
type speakers.




Only if they have some sort of amplification...??



There's a couple of other sockets I'm not too sure about;

below is a link to an image of the sockets,
http://www.3lanes.dsl.pipex.com/temp/phono.jpg

What are the MD sockets for.



That's a little bit confusing as I would guess the Video/Aux and MD

(line
level) to be inputs.

If the Line Out sockets do not provide a line level signal to

another
amplifier/recorder/whatever then they are possibly an input for

another
gadget's Line Out sockets, IYSWIM - poor labelling or poor grouping,

I would
say, but you are unlikely to do any great harm if you have a bit of

a poke
about with another source....??

Volume control set very low, of course....







Line out is to feed to another appliance - in this case since it has
an input for Mini-Disc then it is safe to assume that the output is
intended to permit recording of whatever source is selected on the
music centre.


--
Woody

harrogate3 at ntlworld dot com




All times are GMT. The time now is 02:13 AM.

Powered by vBulletin® Version 3.6.4
Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.
SEO by vBSEO 3.0.0
Copyright ©2004-2006 AudioBanter.co.uk